Oriel — AI & technology worth noticing, every day.

How to make a CNC plasma cutter with high-frequency start

Web page · https://incoherency.co.uk/blog/stories/cnc-plasma-cutter.html

First seen by Oriel on .

AI summary

The author built a workable CNC plasma cutter around an HF start Parkside PPS 30 B2 by replacing the interference-prone USB controller connection with FluidNC over WiFi.

  • HF ignition disconnected UGS from Grbl over USB, but Grbl continued buffered motion, showing that electromagnetic interference primarily affected the serial connection.
  • An Arduino Nano ESP32 runs FluidNC, with a 74HCT245 used for 3.3v-to-5v output level shifting and Leadshine easy servos operating from a 12v supply.
  • The motion platform uses steel box section, 608 bearings, GT2 belts, and ABS-GF printed parts, though non-adjustable bearing rails introduced unwanted play.
  • FluidNC controls the torch relay through M3/M5 commands, requiring a non-zero spindle speed such as M3 S1; a separate enable switch prevents accidental ignition.
  • The machine cut 3mm steel with underside slag and axis-dependent bevel, but struggled with 4mm steel despite documentation claiming capacity up to 12mm.

#cnc plasma cutting #fluidnc #esp32 #electromagnetic interference

Generated by gpt-5.6-sol. Check the original for details.

Metric trends

Last 30 days · Up to 120 recorded samples per source and metric, with reposts kept separate · First and latest retained

Points

Score reported by the source.

  • Hacker News: 46, latest observation ; +39 over observed period since

Comments

Comment count reported by the source.

  • Hacker News: 13, latest observation ; +12 over observed period since

Aliases

SourceExternal IDURL
Hacker News50412715https://incoherency.co.uk/blog/stories/cnc-plasma-cutter.html Read discussion