Testing a Trash Can Faraday Cage
Web page · https://jefftk.com/p/testing-a-trash-can-faraday-cage
First seen by Oriel on .
AI summary
This article tests a galvanized trash can as a Faraday cage, finding its lid leaks at some frequencies but conductive seam tape makes shielding undetectable across 24 MHz–1.7 GHz.
- The setup used a broadband noise generator, a 29-inch antenna, and a Nooelec NESDR SMArt v5 scanning 100 kHz slices from 24 MHz to 1.7 GHz.
- With the lid installed, attenuation reached about 29 dB at 1.2–1.7 GHz, but narrow leaks appeared, including one around 339 MHz.
- Taping the entire lid seam prevented source detection at every tested frequency, including frequencies where the untaped lid leaked.
- Measurements were weakest below 100 MHz because of antenna limitations, broadcast interference, receiver range, and predominantly electric-field coupling.
- The author considers equipment off and unplugged probably sufficient, but recommends a taped trash can for additional EMP protection.
#faraday cages #electromagnetic pulse #radio frequency
Generated by gpt-5.6-sol. Check the original for details.
Metric trends
Last 30 days · Up to 120 recorded samples per source and metric, with reposts kept separate · First and latest retained
Points
Score reported by the source.
- Hacker News: 91, latest observation ; +82 over observed period since
Comments
Comment count reported by the source.
- Hacker News: 66, latest observation ; +66 over observed period since
Aliases
| Source | External ID | URL |
|---|---|---|
| Hacker News | 50467278 | https://www.jefftk.com/p/testing-a-trash-can-faraday-cage Read discussion |